Today actually the pull start spring of the RC car popped. I'm going to fix that bow. While driving my brother's car one day, a little friend of ours came to us. “My car is beautiful,” he said. Thank you. That's where I'm trying to run. I am making preparations. Then he said again, brother, your car is very nice, he said. I said thank you. he said it's beautiful or something. He says it with good intentions. Then of course he said it 10-15 times. I would start the car. I took a shot of "pull start". it didn't work. I took the second one, it didn't work. I took a third shot and the spring in the "pull start" broke up. I did n't take it very hard, but my friend probably deserved it.
But there is no problem. Thank you. I will fix it now. The car was lying down. I will deal with it. If you want, I can share this experience with you. First thing I want to do is fix the "pull start" over there. As you can see the string is out, the spring is not rewinding it. It is waiting like this. I'm going to disassemble the engine and then remove that "pull start" on the back. I'll see if I can fix this first . Those interiors of the car are extremely dirty. The gas tank or something is pretty mediocre. This car should not be like this so that it can run in a healthy way. One of the projects I want to do is to produce an RC car in this way with 3D writing. This car runs on nitro fuel.
The car I want to build is electric and I want to modify that car more on drift. I will also make some modifications on this vehicle. But that project excites me a lot. and by the way, one of the aspects that I don't like is very low, that is, very close to somewhere. Right now, it's on the ground when I press it in the air, it's on the ground when I press it. Since this is an Onroad vehicle, it's actually normal, but I want a slightly higher vehicle . I want it to be a little bit more like a rally car, a little bit lighter. I will make the necessary modifications for it. and the car I want to make is 2 pulls, so actually pushes from the back . I will use it. It will be idle in the front.
Normally, RC vehicles use 4 wheel drive while drifting, but I don't like it that much, so I don't know how it would be to drift with a rear wheel drive car. I will have tested it too. Of course, this project is not something that will come out in 1-2 days, it is a very long-term project, now let's try to disassemble this engine if you want. After that, let's fix the "pull start" spring in the back. This is the carburetor, it filters the particles coming from the outside in the air filter and sends them to the engine, anything should escape into the carburetor right now.
Because the room then goes to the engine. And when it goes to the engine, if it gets between the piston and the liner while the engine is running , it can scratch it. When it draws, it may cause problems such as poor performance and the engine may not start. Here, I can actually talk about the working logic..
