Base Kit: 1/24 Tamiya Peugeot 307 WRC & Mini-z chassis Kit Advantages of the 1/24 scale: You can choose from a huge number of bodies If you look at the bottom of the transparent showcase, you can see which is rc car. Take out Peugeot 307WRC And the Academy Porsche 959 with a mini-z normal chassis The details are very good even if I didn’t attach small accessories such as antennas. Wheelbase and width are larger than the 959 Modifications are required to use the mini-z chassis. The Porsche 959 is wide, but with a short wheelbase, it fits well in the 1/28 scale min-z chassis except the whee offset..
There is a lot of difference in wheelbase. It's a Mini-Z normal chassis It is a method of extending the length by cutting like this. This is a limousine production style.^^ Discard the middle part These are machined chassis parts and mini-z normal parts. Front gearbox assembly. I cut a little bit to increase the steering angle Tie rod installing Knuckles are installed It is a center shaft made to fit the extended chassis.
Cut the 2mm rod to fit with the chassis and grind the end as shown in the video. Part to fix bearing Cut this part like the video Front upper cover. It is an optional part. This is the main chassis that will replace the middle part that was deleted. 3d modeling of main chassis Made by cnc machining. 3d modeling of side parts Made by 3d printing For drift I used optional rigid axle instead of the differential gear assembly of rear gearbox motor bracket 3d modeling of motor bracket I used powerful optional motor for drift Pinion gear installing This is the back part that was cut earlier These are steering parts.
In order to use a normal servo, tie rod was hand-made to fit the length. This is a steering part too. Install as shown in the video As in the video, I used universal rc parts, instead of mini-Z parts. Therefore, driving is very powerful. Front gearbox installation Part to fix center shaft bearing Installation of spur gear. Install the rear gearbox that was assembled earlier. It’s an upper deck that is designed to extend the length of chassis. 3d modeling of upper deck And cnc machining. It connect the front gearbox and main chassis. It is a post part between the upper deck and the main chassis.
3d modeling of post part I used 5mm aluminum pipe Spacer between the upper deck and the main chassis. 3d modeling of spacer Made by 3d printing Install of battery. I used double-sided tape. Both the ESC and receiver are attached with double-sided tape. Operation test. Good work! This wheel is designed to fit wit increased width. Made by cnc machining too. This is a drift tire designed to fit the/24 scale. If ABS material is used, it will become a drift tire. CNC machining Assembly of wheel & tire The offset of the front and rear wheels is different It is a part that connect the body and main chassis. It is a front part. 3d modeling of fornt part Made by 3d printing It is a part that connect the body and main chassis. It is a rear part. 3d modeling of rear part Made by 3d printing The chassis are complete !! It's so powerful, there is no need more than half the throttle. When driving with the precious scale body, be careful not to break.^^ This Tamiya kit has unique method of fixing the body with bolts, so I used that. Tamiya 1/24 scale body. The precision is the very good.
I enjoy while being careful not to break my body. The advantage of mini-z drift is that you can enjoy watching TV indoors in the Corona era~^^ Incomplete 8 turning Small circle turning powerful circle turning. It has a risk of body crush. Thank you for watching
Please subscribe and like..
